HP ENVY 17 Maintenance And Service Manual page 60
Hide thumbs
Also See for ENVY 17:
- Maintenance and service manual (130 pages) ,
- Reference manual (82 pages) ,
- Getting started (76 pages)
Table of Contents
Advertisement
Remove the WLAN module:
1.
Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The 2/gray WLAN antenna cable is connected to the WLAN module 2/Aux terminal.
2.
Remove the two Phillips PM2.0×4.0 screws (2) that secure the WLAN module to the system
board. (The WLAN module tilts up.)
3.
Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
WLAN module into the WLAN module slot.
NOTE:
If the WLAN antennas are not connected to the terminals on the WLAN module, the protective
sleeves must be installed on the antenna connectors, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
50
Chapter 4 Removal and replacement procedures
The 1/black WLAN antenna cable is connected to the WLAN module 1/Main terminal.
WLAN modules are designed with a notch (4) to prevent incorrect insertion of the
Hide quick links:
Advertisement
Table of Contents
