Beep Symptoms; Post Error Codes - Lenovo ThinkCentre Hardware Maintenance Manual

Machine types: 1729, 1731, 1732, 1734, 1736, 1737, 7074, 7075, 7077, 7078, 7556, and 7559
Hide thumbs Also See for ThinkCentre:
Table of Contents

Advertisement

Diagnostic Error Code
305-000-XXX Monitor DDC Test Passed
305-250-XXX Monitor DDC self test failure
415-000-XXXModem Test Passed
415-XXX-XXX Modem error

Beep symptoms

Beep symptoms are tones or a series of tones separated by pauses (intervals without sound) during POST.
The following tables describes beep symptoms.
Beep Symptom
2 short beeps CMOS setting error
3 short and 1 long beeps DRAM memory error

POST error codes

Each time you power-on the system, it performs a series of tests that check the operation of the system
and some options. This series of tests is called the Power-On Self-Test, or POST. POST does the following
operations.
• Checks some basic system-board operations
• Checks the memory operation
• Starts the video operation
• Verifies that the boot drive is working
If the POST detects a problem, an error message appears on the screen. A single problem can cause several
error messages to appear. When you correct the cause of the first error message, the other error messages
probably will not appear on the screen the next time you turn on the system.
FRU/Action
No action
1. Run the Setup Utility program to enable DDC.
2. Cable
3. Monitor
4. Video card
5. System board
No action
Remove the Modem and re-test the system.
FRU/Action
Common error code, see the detail failure information in
"POST error codes" on page 75.
Perform the following actions in order.
1. Make sure the memory module(s) are properly seated
in the connector(s).
2. Replace the memory module(s).
3. Replace the system board.
Chapter 7
.
Symptom-to-FRU Index
75

Advertisement

Table of Contents
loading

Table of Contents