Lenovo ThinkCentre Hardware Maintenance Manual page 54
Machine types: 3025, 3034, 3131, 3142, 3244, 3257, 3307, 3356, 3467, 3357, 3692, 3853, 4394, 5092, 5226, 5296, 6667, and 6673
Hide thumbs
Also See for ThinkCentre:
- Hardware maintenance manual (546 pages) ,
- Safety and warranty manual (265 pages) ,
- User manual (32 pages)
Table of Contents
Advertisement
Diagnostic Error Code
005-027-XXX Video Configuration/Setup error
005-031-XXX Video Device Cable failure
005-032-XXX Video Device Controller failure
005-036-XXX Video Register error
005-038-XXX System BIOS extension failure
005-040-XXX Video IRQ failure
005-195-XXX Video Test aborted by user
005-196-XXX Video test halt, error threshold exceeded
005-197-XXX Video test warning
005-198-XXX Video test aborted
005-199-XXX Video test failed, cause unknown
005-2XX-XXX 005-3XX-XXX Video subsystem error
006-000-XXX Diskette interface Test Passed
006-0XX-XXX Diskette interface error
006-195-XXX Diskette interface Test aborted by user
48
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Run the Setup Utility program.
2. Video drivers update
3. Video card, if installed
4. System board
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 39.
2. Re-run the test.
3. Replace the component called out in warning
statement.
4. Replace the component under test.
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 39.
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 208.
3. Go to "Undetermined problems" on page 62.
1. Go to "Undetermined problems" on page 62.
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 208.
3. Replace component under function test.
1. Video card, if installed.
2. System board
No action
1. Diskette drive Cable
2. Diskette drive
3. System board
Information only Restart the test, if necessary.
Advertisement
Table of Contents
