Sony DVP-S300 Service Manual page 7

Hide thumbs Also See for DVP-S300:
Table of Contents

Advertisement

6. REPLACING OPTICAL PICK-UP
6-1. Handling
1) A red laser diode for DVD requires more attention to static
electricity than general infrared laser diodes for CD.
Because its durability to static electricity is far weaker than
that of infrared laser diodes, always use an earth band when
handling the optical pick-up block as service parts.
2) As for the flexible board KHS-180A (RP) packed as service
parts, the short lands have been soldered to protect from static
electricity. Accordingly, remove solders when replacing opti-
cal pick-up. (See Fig. 6)
Fig. 6 Flexible board
DVD short land
CD short land
3) In handling the KHS-180A (RP), do not touch inhibited parts
shown in Fig. 7, but grip the slide base bearing and U-shaped
guide.
Laser holder
OEIC
Laser coupler
Fig. 7 KHS-180A (RP)
– 7 –
Slide base bearing
Skew sensor
Lens actuator
covers
Objective lenses
U-shaped guide
Touch inhibited parts
• Objective lens
• Skew sensor
• Laser holder
• Laser coupler
• Flexible board
• OEIC
• Lens actuator covers
Flexible board
Connector

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvp-s305Dvp-s315

Table of Contents