Process After Fixing Flash Error - Sony DSC-W115 Service Manual

Digital still camera
Hide thumbs Also See for DSC-W115:
Table of Contents

Advertisement

1-2-3. Self-diagnosis Code Table
Self-diagnosis Code
Block
Detailed
Function
Code
C
1
3
0
C
3
2
0
E
6
1
0
E
6
1
1
E
9
1
0
E
9
2
0
Note: After repair, be sure to perform "1-3. PROCESS AFTER FIXING FLASH ERROR".

1-3. PROCESS AFTER FIXING FLASH ERROR

When "FLASH error" (Self-diagnosis Code E : 91 : 01) occurs, to prevent any abnormal situation caused by high voltage, setting of the flash
is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by the operations on the HOME screen.
Method for Initializing the Flash Error Code
Initialize
Initializes the setting to the default setting. Even if you execute this function, the images
stored in the internal memory are retained.
1 Select [Initialize] with v/V on the control button, then press z.
The message "Reset to default settings" appears.
2 Select [OK] with v, then press z.
The settings are reset to the default setting.
To cancel initializing
Select [Cancel] in step 2, then press z.
• Be sure not to power off the camera while initializing.
DSC-W110/W115_L2
Symptom/State
The internal memory has experienced a
format error.
"Memory Stick Duo" is unformatted.
1
"Memory Stick Duo" is broken.
"Memory Stick Duo" type error
The camera cannot read or write data
on the "Memory Stick Duo".
1
Trouble with hardware
Difficult to adjust focus
0
(Cannot initialize focus)
Zoom operations fault
0
(Cannot initialize zoom lens.)
1
Abnormality when flash is being charged.
0
Non-standard battery is used.
Format the internal memory.
Format the "Memory Stick Duo".
Insert a new "Memory Stick Duo".
Insert a supported "Memory Stick Duo".
Turn the power off and on again, or taking out and inserting the
"Memory Stick Duo" several times.
Turn the power off and on again.
Retry turn the power on by the power switch. If it does not
recover, check the focus reset sensor of lens block (pin wl of
CN403 on the SY-188 board). If it is OK, check the focus motor
drive IC (IC401 on the SY-188 board).
Retry turn the power on by the power switch. Check the zoom
reset sensor of lens block (pin qs of CN403 on the SY-188
board) when zooming is performed when the zoom button is
operated. If it is OK, check the zoom motor drive IC (IC401 on
the SY-188 board).
Checking of flash unit or replacement of flash unit. (Note)
Use the compatible battery only.
1-2
ENGLISH
JAPANESE
ENGLISH
JAPANESE
Correction

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsc-w110Cybershot dsc-w110Cybershot dsc-w115

Table of Contents