Fujitsu Plasmavision PDS4229W-B Service Manual page 40

10.Removing the Video PCB
Video Unit
∗ The Video PCB can be removed
without moving the Rear Case.
1. Remove the 4 circled screws.
2. Pull out the Video PCB Unit from the
plasmavision.
3. Remove the 5 screws from the
Video PCB Unit.
Note :
Three kinds of screws are used on
this Video Unit.
Be careful not to make any mistakes
when reinstalling.
Video PCB
4. Remove the Video PCB.
– 42 –