Hoover Limited Owner's Manual

Hoover dimension vacuum cleaner models limited and supreme owner's manual

Advertisement

Owner's
Manual
®
Dimension
Vacuum Cleaner
(Including Limited & Supreme models)
®
Read this manual before
operating cleaner

Advertisement

Table of Contents
loading

Summary of Contents for Hoover Limited

  • Page 1 Owner’s Manual ® Dimension Vacuum Cleaner (Including Limited & Supreme models) ® Read this manual before operating cleaner...
  • Page 2: Table Of Contents

    • Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).
  • Page 3: Assembling Cleaner

    Consumer Response Center. This cleaner is intended for household use. Side mounted hose trademark of The Hoover Company STEP 1: Unpack carton Remove all parts from carton and identify each item shown. Make sure all parts, especially...
  • Page 4 ARROW CORD PROTECTOR Rotate cord protector on cord until you see its arrow. (Fig. 4) GROOVE SLOT UPPER HANDLE With arrow on cord protector pointing toward arrow on upper handle, press groove in cord protector into slot in upper handle. (Fig. 5 and 6) CORD PROTECTOR Pull cord tight.
  • Page 5 Push bolt into hole on lower front of handle. (Fig. 11) If bolt will not go through hole easily , check the following: • the bracket is properly positioned (see Fig. 9) • the handle is pushed down completely (see Fig. 10) Place nut in recessed area at back of handle.
  • Page 6 Pull switch lock above ON/OFF switch straight out. (Fig. 19) Dispose of switch lock. Note: If switch lock has come off during assembly make sure switch is in the OFF position (down) before plug- ging cord into electrical outlet. STEP 7: Attach hose and tools With cleaner handle in lowest position, open hose door and...
  • Page 7: Cleaner Description

    Cleaner The assembled cleaner will look like the drawing below. description 1. Handle 2. ON/OFF switch 3. Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right or left for easy cord release. 4. Furniture nozzle 5.
  • Page 8: Carpet Height Adjustment

    Carpet height adjustment The cleaning of carpet and rugs takes place at the nozzle. If it is necessary to raise and lower NOZZLE CONTROL the nozzle for various carpet pile KNOB heights, slide the nozzle control knob to the correct setting. For ease in sliding knob, the handle should be in the upright position.
  • Page 9: Cleaning Tools

    Cleaning tools The cleaning tools allow you to do specific cleaning tasks and to clean hard to reach areas. The tool set includes a hose, extension wand, crevice tool, furniture nozzle and dusting brush. A. Move nozzle control knob Slide nozzle control knob to the Cleaning Tools setting to divert suction to hose and cleaning tools.
  • Page 10 Where to buy Paper bags may be purchased from your local Authorized Hoover Dealer (Depot) or from a Hoover Factory Service Center or use the order form packed with your cleaner. When ordering bags, be sure to give the model number of your cleaner.
  • Page 11: The Belt

    The belt The belt on your HOOVER cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the cleaner and should be checked from time to time to be sure it is in good condition.
  • Page 12 How to replace Disconnect cleaner from electri- cal outlet and detach hose from cleaner. 1. Place handle in operating position and turn cleaner over. To remove bottom plate, insert end of flat screwdriver into wide area of right-hand slot and push SLOT handle of screwdriver to the rear.
  • Page 13: Lubrication

    Carefully remove any obstruction from agitator cavity. AGITATOR CAVITY If no obstruction is found and a problem persists, contact your Hoover Factory Service Center or Authorized Warranty Service Dealer (Depot). Lubrication The motor is equipped with bearings which contain sufficient lubrication for the life of the motor.
  • Page 14: If You Have A Problem

    2.Check fuse or breaker. 3.Replace fuse/reset breaker. Do not send your cleaner to The Hoover Company in North Canton l. Replace belt. for service, this will only result in delay. 2.Replace agitator. If further assistance is needed, contact The Hoover Company 3.Change paper bag.
  • Page 15 2. Hoover Authorized Warranty Service Dealers (Depots) This warranty does not cover pick up, delivery, or house calls; however, if you mail your appliance to a Hoover Factory Service Center for warranty service, transportation will be paid one way. While this warranty gives you specific legal rights, you may also have other rights which vary from state to state (or province).

Table of Contents