Emerson CR202EM8 Service Manual page 18

2. Press [CH o / p] buttons on the service remote
control unit and select "40."
C-SRP
1. Press [MENU] button on the service remote
control unit. Then select "C-SHARP" (C-SRP)
display.
2. Press [CH o / p] buttons on the service remote
control unit and select "40."
Note: BRIGHT data value does not need to be
adjusted at this moment.
4. H f Adjustment
0
Purpose: To get correct horizontal frequency.
Note: Use service remote control unit.
1. Press [2] button on the service remote control unit
and select H-ADJ mode. (By pressing [2] button
the display will change from TV AGC to H-ADJ.)
2. Press [CH o / p] buttons on the service remote
control unit so that display will change "0" ~ "7". At
this moment, Choose "4".
3. Turn the power off and on again. (Main Power
button on the TV unit.)
5. Black Stretch Control Adjustment
Purpose: To show the fine black color.
Symptom of Misadjustment: Black color will not
appear correctly.
Note: Use service remote control unit.
1. Enter the Service mode. (See page 5-1.)
2. Press [0] button on the service remote control unit.
"B-S" is indicated.
3. Press [CH o / p] buttons on the service remote
control unit so that display will change "OFF," "0,"
and "1." Then choose "B-S OFF."
4. Press [0] button on the service remote control unit.
"B-S2" is indicated.
5. Press [CH o / p] buttons on the service remote
control unit so that display will change "0" and "1."
Then choose "B-S2 0."
6. Turn the power off and on again, using the main
power button on the TV unit.
6. Purity Check
1. Enter the Service mode. (See page 5-1.)
2. Press [7] button on the remote control unit. Each
time pressing [7] button on the service remote
control unit, display changes Red mode, Green
mode, Blue mode, and White mode cyclically.
3. Select White mode.
4. Turn the power off and on again. (Main power
button on the TV unit.)
7. SD Check Mode
1. Enter the Service mode. (See page 5-1.)
2. Press [1] button on the remote control unit. The
unit enters the SD-Check mode.
3. The unit starts selecting the added channel from
the first channel according to the memorized CH
ADD/DEL data and CATV/TV data in RAM.
SD Check mode (Factory mode)
Press [1] button.
7
Please wait
OSD color:
Magenta
13
Please wait
When all
OSD color:
channels
Magenta
are SD,,,,
26
OK
OSD color:
Magenta
When SD-Check starting,
there is no ADD channel.
ADD nothing
OSD color:
Magenta
5-3
When the selected
channel is not SD,,,,
30
NG
OSD color:
Magenta
P7150EA