Servicing Note - Sony HCD-EX100 Service Manual

HCD-EX100
ADJUSTMENT OF CAM PHASE
Cam
Boss
SW lever
Insert the cam so that the boss touches the SW lever
at the left shown in the figure.
Note : Set the slider (1) in this location
before inserting the cam.
With the phase adjusted, attach the parts using the following procedure.
STEP1
Insert the boss of the slider (3) in the groove of
the cam.
Boss
STEP2
Set the mecha cover to the groove
on the slider (3) and attach.
Screw
(BVTP2.6x8)
Cover, mechanical
Groove of slider (3)
4
SECTION 1

SERVICING NOTE

Absorber Absorber
Rotate the cam in the arrow direction, and adjust the
phase until the boss touches the SW lever shown in
the figure.
STEP3
Insert the boss of the lever (1) in the hole of the
slider (3) and attach.
Slider (3)
Cam Lever (1)
Hole of slider (3)
STEP4
While bending the slider (2) slightly in the arrow
direction, insert it in the groove of the guides (L)
and (R) and attach.
Screw
(BVTP2.6x8)
Slider (2)
SW lever Boss
Lever (1)
Boss
Screw
Boss
(PTTWH2.6x8)
Guide (R)
Cam
Boss (Four point)
Guide (L)