Remote And Indoor Temperatures; Auto-Scanning; Checking Remote Rainfall Data - Honeywell TC150 User Manual

REMOTE AND INDOOR TEMPERATURES

The remote temperature information is located on the middle line of the
main unit's display. The indoor temperature with the icon IN is located
next to the remote temperature.
The wave icon above the remote channel number indicates the reception
status from the remote temperature sensor.
There are three following types of the reception status that may be
displayed:
The unit is in searching
mode.
Temperature readings are
securely registered.
No signals detected.
NOTE: If the indoor or remote temperature goes above or below
operating range stated in specifications, the main unit's display will show
dashes "- - -"

AUTO-SCANNING

Press and hold the CHANNEL button on the back on the main unit for 2
seconds – the icon " " will appear on the display's middle line below the
remote temperature channel number. All 3 remote temperatures will be
displayed one-by-one automatically for 4 seconds each in the following
sequence: Channel 1, Channel 2 and Channel 3.
To exit from scanning mode, press and hold the CHANNEL button (on
the back) for 2 seconds, and the icon " " will disappear, returning the
main unit to the default display mode.
- - -
17

CHECKING REMOTE RAINFALL DATA

The remote rainfall information line is located on the top line of the main
unit's display.
The rain icon is located to the left of the rainfall reading and indicates
the reception status from the remote rain gauge.
There are three following types of the reception status that may be
displayed:
The unit is in searching
mode.
Rainfall readings are
securely registered.
No signals detected.
Press and hold the MODE button on the front panel to display the rainfall
reading in inches or mm.
RAINFALL HISTORY
The rainfall history records will be automatically stored in the memory of
the main unit. There are three historical records may be displayed – for
the past hour, past day and past week.
To display any of available rainfall history reading, use any button on the
front panel except the ALARM button. The display sequence is: LAST
HOUR, LAST 24 HOURS, and LAST 7 DAYS.
To clear the memory, press and hold MEMORY button on the front panel
for two seconds and all previously stored readings will be erased (all the
historical records will display a default reading 0.00).
17
- - -
18