Sony KP-46WT520 Service Manual page 54

10. Select "GRN MSIZ", and correct the space intervals for the horizontal
section so the screen is equal.
GRN MSIZ (Horizontally)
Push the joystick
to
11. Select "GRN MLIN", and correct the sizes of the horizontal line so the
center of the screen is symmetrical left and right.
GRN MLIN (Horizontally)
Push the joystick
to
Note: The SIZE and LIN, MSIZ and MLIN adjustments
affect each other. If necessary, adjust these mutually.
12. Select "GRN PIN", and adjust so that right and left vertical lines on
the screen become straight. Adjust so that upper and lower horizontal
lines on the screen become straight.
GRN PIN (Horizontally/Vertically)
Push the joystick
to
Push the joystick
to
13. Select "GRN KEY", and adjust so that upper and lower horizontal lines
on the screen become parallel.
GRN KEY (Vertically)
Push the joystick
to
Note: The VPIN and KEY adjustments affect each other.
If necessary, adjust these mutually.
KP-46WT520/51WS520/57WS520
14. Press the "9" button on the remote commander to enter fi ne
15. Make the fi ne adjustment so that horizontal lines and vertical lines
16. Press the "9" button on the remote commander to return to coarse
2) RED ADJUSTMENT
Push the joystick
1. Cover the blue CRT lens with a lens caps to allow only the green and
to
2. Press the "3" button on the remote commander to select RED mode.
3. Adjust the following items so that red lines overlap with green lines.
Push the joystick
to
4. Press the "9" button on the remote commander to enter fi ne
5. Make the fi ne adjustment so that horizontal lines and vertical lines
6. Press the "9" button on the remote commander to return to coarse
Note: If lens caps are unavailable, you can cut off the unnecessary color
beams by controlling the service mode MCP-RON, GON, BON.
Push the joystick
to
3) BLUE ADJUSTMENT
1. Remove the lens cap from the blue picture lens to display all colors.
2. Press the "3" button on the remote commander to select BLU mode.
3. Adjust the following items so that blue lines overlap with green lines.
Push the joystick
to
4. Press the "9" button on the remote commander to enter fi ne
5. Make the fi ne adjustment so that horizontal lines and vertical lines
6. Press the "9" button on the remote commander to return `to coarse
Note: When replacing CRTs, adjust the set-up adjustments (2-1 to 2-9)
and the registration adjustment (2-12). When replacing multiple CRTs at
the same time, replace and adjust them individually.
Push the joystick
to
adjustment mode.
become straight.
adjustment mode.
red to show (or use the method shown in the note below for turning off
the CRTs individually without using lens caps).
• RED CENT (horizontally/vertically)
• RED SKEW (horizontally/vertically)
• RED SIZE (horizontally/vertically)
• RED LIN (horizontally/vertically)
• RED MSIZ (horizontally)
• RED MLIN (horizontally)
• RED PIN (horizontally/vertically)
• RED KEY (vertically)
adjustment mode.
overlap with green lines.
adjustment mode.
• BLU CENT (horizontally/vertically)
• BLU SKEW (horizontally/vertically)
• BLU SIZE (horizontally/vertically)
• BLU LIN (horizontally/vertically)
• BLU PIN (horizontally/vertically)
• BLU KEY (vertically)
adjustment mode.
overlap with green and red lines.
adjustment mode.
KP-46WT520/51WS520/57WS520
54