JVC DX-T9 Service Manual page 57
Jvc compact component system service manual
Hide thumbs
Also See for DX-T9:
- Instructions manual (52 pages) ,
- Service manual (170 pages) ,
- Service manual (16 pages)
Advertisement
9. Micon version display
TEMPORARY DISPLAY FOR MICON VERSION (5SEC)
After 5 seconds, return to previous display.
Each key press will toggle temporary display for the
following:
SYSCON VERSION
DVD LSI (BE) VERSION)
DVD MECHA VERSION
DVD LSI (BE & FE) VERSION CAN ONLY BEEN
DISPLAY DURING
SYSTEM POWER ON IN DVD MODE
(WHEN DVD LSI P.ON)
IF THERE IS NO INFORMATION FEEDBACK,
SYS-CON WILL DISPLAY
"WAIT" BLINKING 0.5SEC ON & OFF
Press the [STANDBY], [ENTER] and [SET] keys on the
remote controller simultaneously in power on state .
FL indication
SYSCON VERSION
" xxxxxx-xxx "
Press the [STANDBY], [ENTER] and [SET] keys again on
the remote controller simultaneously in power on state .
FL indication
DVD LSI (BE) VERSION)
" xx xxxx "
Press the [STANDBY], [ENTER] and [SET] keys again on
the remote controller simultaneously in power on state .
FL indication
DVD MECHA VERSION
" xx xxxx "
Press the [STANDBY], [ENTER] and [SET] keys again on
the remote controller simultaneously in power on state .
10. LCD all segment blinking
LCD ALL SEGMENT BLINKING (0.5sec:ON/0.5sec:OFF)
Each key press will toggle this TEST mode ON/OFF.
Press the [STANDBY], [ENTER] and [+10] keys on the
remote controller simultaneously in power on state .
LCD all segment blinking.
11. Tuner version
Each Key pressed will display the current Sys-con
Tuner Version for 5 seconds and then changed back
to previous display.
U1 - 9KHz
Display: " 0V USNE 9K "
U1 - 10KHz Display: " 0V USNE10K "
U2 - 9KHz
Display: " 1V UW
9K "
U2 - 10KHz Display: " 1V UW
10K "
U3 - 9KHz
Display: " 2V UX
9K "
U3 - 10KHz Display: " 2V UX
10K "
U4 - 9KHz
Display: " 3V A
9K "
U5 - 9KHz
Display: " 4V UY
9K "
U5 - 10KHz Display: " 4V UY
10K "
Press the [STANDBY], [ENTER] and [1] keys on the
remote controller simultaneously in power on state .
FL indication
Example)
0V USNE 9K
" xx xxxx xx "
This check is completed.
12. DVD test mode
Enters DVD-TEST mode.
DVD-TEST mode specification based on DVD-MODULE
specification. To exit DVD-TEST mode, AC OFF the system,
then AC ON again.
For Region Rewrite and DVD-AUDIO Device Key Writing,
refer to Region Rewrite and Device Key Writing section
below for exit procedure.
Insert a power cord in an outlet while pressing
the [STOP] and [DISC 5 EJECT] buttons on the
main unit simultaneously .
This unit is set to DVD test mode.
The details refer to "4.3.3 DVD test mode".
13. DVD initialize
DVD module initialized.
Display will return to DVD Test Mode Area display
(" T xxy vw "). Press Power key to exit this TEST mode.
DVD test mode.
Press the [PAUSE] key
on the remote controller .
Wait for 10 seconds.
DVD initialize is completed.
(No.MB368)1-57
Advertisement
