Installer System Test - Honeywell FocusPRO TH6220D Installation Manual

FocusPRO ™ TH6220D Programmable Thermostat

Installer system test

Follow the procedure below to test the heating, cooling and fan.
To begin, press and hold the
buttons until the display changes
System Test
10 Heating system
20 Emergency
heating system
30 Cooling system
40 Fan system
70 Thermostat
information
(for reference only)
CAUTION: EQUIPMENT DAMAGE HAZARD
Compressor protection (minimum off time) is bypassed during testing. To prevent
equipment damage, avoid cycling the compressor quickly.
and
System Status
0 Heat and fan turn off
1 Heat turns on. Fan also turns on immediately if Function 1 is set
to "1" or "5," or if Function 3 is set to "1"
2 Second stage heat turns on
0 Heat and fan turn off
1 Heat and fan turn on
2 Second stage heat turns on (Aux)
0 Compressor and fan turn off
1 Compressor and fan turn on
2 Second stage compressor turns on
0 Fan turns off
1 Fan turns on
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
System test
number
10
Done
Press
Press
Press
N N E E X X T T
Press
D D O O N N E E
13
System
status
Next
to turn on system
to turn off system
to advance to next test
to terminate system test
**See page 11
0