Toshiba D-VR5SU Service Manual page 52

Hi-fi vcr & dvd video recorder
Hide thumbs Also See for D-VR5SU:
Table of Contents

Advertisement

[OK]
Tension Connect
[NG]
Tension Connect
Tension Connect
2-7: T BRAKE ARM/T BRAKE BAND (Refer to Fig. 2-7-A)
1.
Remove the T Brake Spring.
2.
Turn the T Brake Arm clockwise and bend the hook
section to remove it.
Unlock the 2 supports 1 and remove the T Brake Band.
3.
T Brake Band
1
1
NOTE
1. In case of the T Brake Band installation, install correctly
as Fig. 2-7-B.
[OK]
T Brake Band
[NG]
T Brake Band
2-8: S REEL/T REEL/IDLER ARM ASS'Y/IDLER GEAR
(Refer to Fig. 2-8-A)
1.
Remove the S Reel and T Reel.
Remove the 2 Polyslider Washers 1.
2.
3.
Remove the Idler Arm Ass'y and Idler Gear.
DISASSEMBLY INSTRUCTIONS
Tension Band
Tension Band
Fig. 2-6-D
Main Chassis
Fig. 2-6-E
Hook section
T Brake Arm
T Brake Spring
Fig. 2-7-A
T Brake Arm
T Brake Arm
Fig. 2-7-B
NOTE
1.
Take care not to damage the gears of the S Reel and T
Reel.
2.
The Polyslider Washer may on the back of the reel.
3.
Take care not to damage the shaft.
4.
Do not touch section "A" of S Reel and T Reel. (Use
gloves.) (Refer to Fig. 2-8-A) Touching may leave stains
on section "A".
5.
When you install the reel, clean the shaft and grease it. (If
you do not grease, noise may be heard in FF/REW
mode.)
6.
After installing the reel, adjust the height of the reel.
(Refer to MECHANICAL ADJUSTMENT)
Idler Gear
S Reel
(A)
NOTE
1.
In case of the S Reel and T Reel installation, check if the
correct parts are installed. (Refer to Fig. 2-8-B)
2.
In case of the Idler Arm Ass'y installation, install correctly
as Fig. 2-8-C. And also set it so that the section "B" of
Fig. 2-8-A is placed under the Main Chassis tab.
[OK]
Clutch Gear
[NG]
Clutch Gear
B2-3
Idler Arm Ass'y
(B)
T Reel
1
1
Big Hole
Small Hole
(S Reel)
(T Reel)
Idler Arm Ass'y
Idler Arm Ass'y
D-VR5SU/D-VR5SC
(A)
Fig. 2-8-A
Fig. 2-8-B
Fig. 2-8-C

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

D-vr5sc

Table of Contents