Door Removal - Kenmore 970R7030 Series Use & Care Manual

Door Removal Instructions (Continued)
Once both doors are in place, ensure they
are aligned with each other and level
(Please see the "Installation" section for more
details), and replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal
injury, or damage to the doors or handles.
Removing Freezer Door
1. Open freezer door.
2. Remove door screws on right and left
sides (two screws on each side).
Remove
CAUTION
Door is heavy. Use caution when lifting.
3. Lift door up and out to remove.
Installing Freezer Door
1. With lower slides pulled out, hang door
onto slide brackets ensuring pins on each
side are fully inserted into slots on each
side.
Pin
Slot
Do NOT
Remove
Cabinet
2. Reinstall screws (two per side), fully finger
tighten, and close door.
Reinstall
and
tighten
till
finger
tight
3. Check gasket seal around top, bottom,
and sides of freezer door. If gasket is
not sealed, rotate door until the gasket is
sealed.
4. Open door by grabbing in the center
sides of the door. Be careful not to
rotate door when opening.
Push
Against
Freezer
Door
Check
Seal
5. Tighten large bolts.
Fully
tighten
large
bolts
6. Recheck gasket seal.
7. Install the toe grille by fitting into place.
15
Do
NOT
Remove
Grab
Door
at Center
from Both
Sides
Then
Pull
Door
Out
Do
NOT
Remove