Installer System Test - Honeywell SERIES 2000 T7300D User Manual

T7300D SERIES 2000 COMMERCIAL MICROELECTRONIC THERMOSTAT
4.. Press Run Program.
Run
Program
Set Program
Run Occupied Unoccupied
Program Start Time Start Time
Temporary Set Current Clear
Occupied Day/Time Start Time
Continous
Unoccupied

INSTALLER SYSTEM TEST

Use the Installer System Test to check the thermostat
configurations and operation. Refer to Table 3 for a list of
the available system tests.
Table 3. Tests Available in Installer System Test.
Test
Number System Test Description
10 to 19 Heating equipment can be turned on and off
30 to 39 Cooling equipment can be turned on and off
40 to 49 Fan equipment can be turned on and off
60 0 to Keyboard keys test
60 19
70 to 79 Thermostat information including date code,
software versions and subbase identification
are displayed
To start the system test:
CAUTION
The minimum off time for compressors is bypassed
during the Installer System Test. Equipment
damage can occur if the compressor is cycled too
quickly.
Key to
Press
Heating Equipment System Test
Heat/Cool Settings
62-0123—3
AM
Set Temperature Change
Time/Temp
Occupied Unoccupied
Day Temp Temp
Mon
Occupied 1
Heat/Cool
Copy Settings
System
System Fan
Heat
Table 4. Installer System Test Options.
Test
Number
10 Enter heating equipment system test.
11 Stage-one heat comes on. When Installer Setup number 02 is 01, the system fan
is also energized.
12 Stage-two heat comes on. Stage-one heat and system fan remain on.
13 Stage-three heat comes on. Stage-one and stage-two heat with the system fan
are on.
12 Stage-three heat turns off.
11 Stage-two heat turns off.
10 Stage-one heat and system fan turn off.
Press and hold the increase
the same time, until 10 appears. All segments of the LCD
are displayed for three seconds before 10 appears. See
Room
Fig. 5 and 6.
Fan
Auto
M4954A
Set Program Set Program
Em Ht Em Ht
Aux Ht Aux Ht
Comm
Mon TueWedThuFriSatSun
Un Occupied 12 Override
System
Em Heat Off
Fig. 5. Display of all the segments of the LCD.
Refer to Table 4 and Thermostat Information section for
directions and results of the specific system tests.
NOTE: Press Run Program to exit the system test. The
system test times out after four minutes without
any key presses.
Description
6
and
Temporary Setting Enrg
Start Time Set Day/Time Set Day/Time
AM
PM
Heat
In Recovery
Lo
Med Hi
Cool Auto Wait
TEST NUMBER
Fig. 6. Display of test number.
decrease keys, at
Sav
Room
%Humid
Cool Remote
Auto Only Duct
Fan
On Auto
M4916
M10257A
(continued)