Docking An Ipod/Iphone - Bowers & Wilkins Zeppelin Owner's Manual

Docking an iPod/iPhone

To dock your iPod/iPhone, simply angle it, locate
the long socket over the connector on the support
bracket and push down fully.
The spring-loaded design automatically adjusts
for all models and causes the iPod/iPhone to rest
on the back support.
There's plenty of room to get your hand round
the back of the support to operate the player's own
controls in the normal way. Note that, because the
socket in the base of 1st, 2nd and 4th generation
nanos is offset to one side, they will not sit centrally
on the support bracket.
As soon as you dock your iPod/iPhone, Zeppelin
automatically selects it as the source. If Zeppelin
is in standby, it will automatically turn itself fully on
without you having to press either
LED will glow yellow for a couple of seconds while
the amplifier initialises and then turn to blue when
Zeppelin is ready to play.
If your iPod/iPhone was turned off or in pause
mode when you docked it, it will end up in paused
mode. If it was playing, it will continue to play.
All the time your iPod/iPhone is docked and
Zeppelin is plugged into the power supply, your
iPod/iPhone will charge (except for Group A and
button. The Group B devices). If that's all you want it to do,
put Zeppelin into standby to reduce power
consumption using the
Zeppelin or on the remote handset.
If you remove your iPod/iPhone while it is the
selected source, Zeppelin will automatically go
into standby after 5 minutes to reduce power
consumption.
button, either on
9