Download  Print this page

Mercury Notice - Honeywell CT54 Installation Instructions Manual

Honeywell thermostat user manual
Hide thumbs
   

Advertisement

CT54 THERMOSTAT

MERCURY NOTICE

If this thermostat is replacing a control that
contains mercury in a sealed tube, do not place
the old thermostat in the trash. Contact your local
waste management authority for instructions
regarding recycling and proper disposal of this
control or of an old control containing mercury in
a sealed tube.
STEP 3. CONNECT WIRES TO NEW
THERMOSTAT
IMPORTANT
All wiring must comply with local building codes
and ordinances. If you are unsure about house-
hold wiring procedures, please call your local
heating/cooling contractor.
1. Remove the cover on the new thermostat. To
remove the cover, insert your thumb into the inden-
tation on the bottom and pull the cover away from
the thermostat (see Fig. 3).
2. Loosen the R and W terminal screws on the back
of the new thermostat (see Fig. 4).
3. Remove the two wires from the pencil and attach
one wire to the R terminal and the other wire to the
W terminal (see Fig. 4 and 5).
4. Plug the hole in the wall with insulation to prevent a
warm or cool draft from affecting the operation of
the thermostat.
COVER
Fig. 3. Remove cover on new thermostat.
69-1696EF
BOTTOM OF
THERMOSTAT
M19646
Fig. 4. R and W terminals on new thermostat.
FOR WRAPAROUND
INSERTION STRIP
7/16 IN. (11 MM)
Fig. 5. Wraparound and straight wiring connections.
STEP 4. MOUNT NEW
THERMOSTAT TO WALL
1. Position the thermostat on the wall. Place a level
on top of the thermostat and use a pencil to mark
the two mounting holes on the wall (see Fig. 6).
2. Move the thermostat to the side and drill the
mounting holes in the wall using a 1/16 in. drill bit
at the locations you marked.
3. Position the thermostat over the drilled holes and
loosely insert the mounting screws into the drilled
holes. Check the leveling of the thermostat and
tighten the mounting screws. Do not over tighten.
LEVEL
.18
.2
.25
MOUNTING
HOLE
NOTE: MOVE TEMPERATURE
LEVER IF IT BLOCKS
MOUNTING HOLE
Fig. 6. Mount new thermostat to wall.
2
FOR STRAIGHT
INSERTION
STRIP
5/16 IN. (8 MM)
M19648
.9
.7
.5
.4
MOUNTING
.3
HOLE
M19647
M19649

Advertisement

loading

  Related Manuals for Honeywell CT54