Setting Access Codes (External Line Prefixes); Setting Pauses - Siemens Gigaset A580IP Manual

Operating the base station on the PABX

Setting access codes (external line prefixes)

Depending on your PABX, you must dial an access code before making external
calls in order to obtain an external line. You can store this access code in your
phone. It is then added automatically to the numbers, e.g. when dialling using the
calls list.
¢
§Menu§
Access Code
~
a
If an access code is set, the following applies:
u
The access code is added automatically when dialling from the calls list and
when dialling emergency numbers and SMS centre numbers.
u
When dialling numbers manually and dialling numbers from the directory you
must add the access code yourself.

Setting pauses

Changing the pause after line seizure
You can set the length of the pause inserted between pressing the talk key c and
sending the phone number.
M 4 O L
§Menu§
~
Changing the pause after the recall key
You can change the length of the pause if your PABX requires this (refer to the user
guide for your PABX).
M 4 O
§Menu§
~
108
¢ ¢
Settings Base
§OK§
Select and press
Enter or edit the access code (maximum three digits) and press
Press and hold (idle status).
Enter a number for the length of the pause (1 = 1 sec.; 2 = 3 sec.;
3 = 7 sec.) and press
Enter a number for the length of the pause (1 = 1 sec.; 2 = 2 sec.;
3 = 3 sec.; 4 = 6 sec.) and press
Additional Features
.
§OK§
.
§OK§
.
§OK§
.