Amped Wireless SR10000 User Manual page 43

SR10000
I cannot connect to my Home Network. I received an Error when running the Smart Setup Wizard.
a. Your Home Network may be secured. Double check that you have the correct security key to connect
to the Home Network.
b. Your Smart Repeater may be located too far from your Home Network. Run through the Setup
Wizard again. On the SCAN page, your Home Network should show a signal strength of 70% or
greater. If it does not, move the Smart Repeater closer to your Home Network and try again.
c. Check to see that your Home Network router's DHCP server is enabled. The Smart Repeater needs to
obtain an IP from your Home Network router.
I cannot find my Home Network when scanning for wireless networks in the Smart Setup Wizard
a. The Smart Repeater may be out of range. Move the Smart Repeater closer towards the wireless
router and try the Setup Wizard again from the Web Menu. It is recommended that your Home
Network shows a signal strength of 70% or greater in the Smart Setup Wizard SCAN results.
b. The Home Network may be a dual band wireless router. The Smart Repeater supports 802.11b/g/n
2.4GHz routers. If your Home Network uses a dual-band router, it will not work with the Smart
Repeater. Adjust the dual-band router's configuration to disable the 5GHz band.
c. Go to the Smart Features tab in the web menu and access the Wireless Coverage Controls. Make sure
the setting is at 100% and try again.
USER'S GUIDE
42