Download  Print this page

Powering Up And Setting The Temperature - Honeywell AQ1000TP2 Owner's Manual

7-day programmable hydronic thermostat
Hide thumbs

Advertisement

Table of Contents

Powering up and setting the temperature

Powering up
The thermostat is powered through the AQ2000 hydronic control panel. It turns on when the zoning module is
energized.
At power-up, the message
configured for ALL-ZONES scheduling (see page 19). In this case, at first power-up, the thermostat will adopt
the schedule settings from the AQ2000 hydronic control panel*. All thermostats configured for ALL-ZONES
scheduling should have therefore the same schedule settings.
* If the AQ2000 controller does not support ALL-ZONES scheduling (manufactured prior to V2 software
build), at first power-up the thermostat will initially retain its schedule settings. However, as soon as any
modification is made to any of the thermostats configured for ALL-ZONES scheduling, all the other thermostats
will adopt the schedule of that thermostat.
Setting the Temperature manually
The thermostat displays the actual (measured) temperature of the zone.
To display the setpoint temperature, press the
the next 5 seconds.
thermostat is maintaining the temperature at the heating setpoint or cooling setpoint respectively.
To change the setpoint, press the
faster, press and hold the button.
NOTE: If the hydronic control panel has locked the thermostat's keypad,
means the thermostat settings cannot be changed.
ALL ZONES SCHEDULE
or
SET HEAT
SET COOL
or
will flash for the first 15 seconds if the thermostat has been
or
button once. The setpoint will be displayed for
appears at the same time as the setpoint to indicate the
button until the desired temperature is displayed. To scroll
3
appears on the screen. This
69-2245EF

Advertisement

Table of Contents
loading

  Related Manuals for Honeywell AQ1000TP2