iPGSM-COM Commercial Fire Communicator – Installation and Setup Guide
PowerBoost1 Module Information
LOW BATT (yellow)
If AC power is lost and the battery voltage falls below 10v, the module's output voltage will be
turned off. The output power is turned back on when AC power is restored.
You must use the DIP switch settings shown below.
AC power available.
Cyclical flashing – normal communications.
Repetition of 3 flashes – loss of communications.
Missing or low battery.
One or more trouble conditions exist, such as; overload, output supervision,
ground fault, or charger failure.
LOW BATT LED
Confiure DIP switch
2 3 4
(Switch handle = white)
– 9 –
2 3 4