iPGSM-COM Commercial Fire Communicator – Installation and Setup Guide
Dialer Capture Module Information
RED – Steady ON
RED – Flashing
GREEN – Steady ON
GREEN – Blinks every 2 sec.
GREEN – Blinks twice every sec.
GREEN – Blinks 10 times every sec.
LED Board Information
Messages exist in buffer.
No messages to be sent. Waiting for messages.
PowerBoost1 communication problem.
Communication Module connection is lost.
PowerBoost1 and Communications Module connection is lost.
Dialer Capture Module
Yellow – ON when radio trouble is present.
Buzzer – Upon loss of AC power, this will
beep once every 10 seconds.
Yellow – ON when battery is low.
Yellow – (not used)
Yellow – ON when no AC is present.
Green – ON when AC is present.
Note: Telco ports 1 (primary dialer)
and 2 (secondary dialer) may be
used instead of the terminal board.
Whichever connection method is
used, both Telco paths must be
connected to the Fire Panel.
– 8 –