Samsung VP-D101 Service Manual page 15

2-4 Deck Adjustmant
2-4-1 Operation Without Housing Assembly
1) Remove the Housing Ass'y from the Deck Ass'y.
2) Connect the Mechanical Chassis to the recorder
circuit to supply voltage.
3) Set to Unload mode.
2-4-2 Setting Mechanical Mode (Without Recorder Circuit)
1) Set the power-supply output to approx. 3V~5V.
2) Choose the polarity (depending on whether load-
ing or unloading).
3) Supply the voltage to the Motor Loading, and set
to the desired mode.
DC POWER SUPPLY
Samsung Electronics
4) Press the S/W Push (Keep ON status)to start load-
ing, and push the PLAY Key.
(Cover the Top/End sensor with black tape,
because they do not operate.)
Note : For the removal of the Housing Ass'y refer to
4-2-2 (Training Manual ; page 4-8).
Connceted the Recorder Circuit
SWITCH C-IN
Fig. 2-15
A B
+ -
- +
Fig. 2-16
Alignment and Adjustments
<Table 2-5>
Movement of Chassis
Unloading
Loading
A
B
2-11