All Symbologies; Message Length - Honeywell 3800g User Manual

All Symbologies

If you want to decode all the symbologies allowable for your imager, scan the
All Symbologies On code. If on the other hand, you want to decode only a
particular symbology, scan All Symbologies Off followed by the On symbol for
that particular symbology.
All Symbologies On

Message Length

You are able to set the valid reading length of some of the bar code symbologies.
If the data length of the scanned bar code doesn't match the valid reading length,
the imager will issue an error beep. You may wish to set the same value for
minimum and maximum length to force the imager to read fixed length bar code
data. This helps reduce the chances of a misread.
EXAMPLE: Decode only those bar codes with a count of 9-20 characters.
Min. length = 09
EXAMPLE: Decode only those bar codes with a count of 15 characters.
Min. length = 15
For a value other than the minimum and maximum message length defaults,
scan the bar codes included in the explanation of the symbology, then scan the
digit value of the message length and Save bar codes on the
inside the back cover of this manual. The minimum and maximum lengths and
the defaults are included with the respective symbologies.
7 - 2
Max. length = 20
Max. length = 15
3800g/3800gHD/3800gPDF User's Guide
All Symbologies Off
Programming Chart