Intercharacter Delay; User Specified Intercharacter Delay - Honeywell 3800g User Manual

Intercharacter Delay

An intercharacter delay of up to 495 milliseconds may be placed between the
transmission of each character of scanned data. Scan the Intercharacter
Delay bar code below, then scan the number of milliseconds and the SAVE bar
code using the Programming Chart
To remove this delay, scan the Intercharacter Delay bar code, then set the
number of steps to 0. Scan the SAVE bar code using the
inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 495 milliseconds may be placed after the trans-
mission of a particular character of scanned data. Scan the Delay Length bar
code below, then scan the number of milliseconds and the SAVE bar code using
the Programming Chart
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value
for the ASCII character that will trigger the delay
Page 1252) on page A-2.
Delay Length
To remove this delay, scan the Delay Length bar code, and set the number of
steps to 0. Scan the SAVE bar code using the
back cover of this manual.
3800g/3800gHD/3800gPDF User's Guide
inside the back cover of this manual.
Prefix Scanned Data
1 2 3
Intercharacter Delay
Intercharacter Delay
inside the back cover of this manual.
Suffix
4 5
Programming Chart
ASCII Conversion Chart (Code
Character to Trigger Delay
Programming Chart inside the
4 - 5