Multiple Symbols; No Read - Honeywell 3800g User Manual

When the output sequence is Off , the barcode data is output to the host as the
image scanner decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Required
On/Not Required
*Off

Multiple Symbols

When this programming selection is turned On , it allows you to read multiple
symbols with a single pull of the imager's trigger. If you press and hold the trig-
ger, aiming the imager at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. The imager attempts to find and decode
new symbols as long as the trigger is pulled. When this programming selection
is turned Off , the imager will only read the symbol closest to the aiming beam.
On
* Off

No Read

With No Read turned On , the imager sends an "NR" to the host if you pull and
release the trigger without reading a code (e.g., bad bar code). If No Read is
turned Off , the "NR" will not be sent to the host.
On
* Off
If you want a different notation than "NR," for example, "Error," or "Bad Code,"
you can edit the output message using the Data Formatter (page 5-5). The hex
code for the No Read symbol is 9C.
3 - 12 3800g/3800gHD/3800gPDF User's Guide