Motor Control Module Reset Error; Water Leak Fault - Fisher & Paykel SmartDrive Service Manual

35. (00100011) Phase 1 - Motor Control Module Reset
The Display Module has sent a false signal to the Motor Control
Module.
Primary Source:
Action:
Secondary Source: Display Module.
Action:
36. (00100100) Phase 1 to 6 - Water Leak Fault
The Motor Control Module has needed to top up the water level more
than 4 times during agitate. This is excessive, as normally only one or
two top ups are required to replace the air that has escaped from a full
load during agitate. The most likely cause is that the SmartDrive is
siphoning. The other alternative is that the SmartDrive has developed
a leak.
Primary Source:
Action:
Secondary Source: Mechanical.
Action:
Tertiary Source:
Action:
Error
12 way Harness Connection.
Check the 12 way harness connection between
the Display Module and the Motor Control
Module.
Replace the Display Module.
Pump System.
1. Check the height of the drain hose outlet.
Minimum 850mm, maximum 1200mm.
2. Check that the hose guide is fitted and check
that the hose does not protrude more than
20mm beyond the guide.
1. Check the pressure tube connections on the
outer bowl and Motor Control Module.
2. Check that the drive shaft seal and the pump
housing seal have not developed a leak.
Motor Control Module.
Phase1.)
Replace Motor Control Module.
Module Phase 1.)
28
(Display Module
(Display