Tools Required For Installation - Honeywell CT8611 Installation Manual

TOOLS REQUIRED FOR INSTALLATION

Assemble a flat blade screwdriver and other
tools as needed (right).
Test to make certain that your heating and
cooling systems are working properly. If either
does not work, contact your local heating/air condi-
tioning dealer. To avoid compressor damage, do
not operate the cooling system if outdoor tempera-
ture is below 50 F [10 C].
TURN OFF POWER to the system at the heat
pump and at the fuse/circuit breaker panel.
Carefully unpack your new thermostat. Save
instructions, proof of purchase from packag-
ing and original receipt.
FLAT BLADE
SCREWDRIVER
WIRE CUTTER/STRIPPER OR SHARP
KNIFE, IF NEEDED TO STRIP WIRES
SPIRIT LEVEL, IF NEEDED TO LEVEL
THERMOSTAT FOR APPEARANCE
4
HAND OR POWER
DRILL WITH 3/16 INCH
DRILL BIT, IF NEEDED TO
DRILL HOLES IN WALL
MASKING TAPE, IF NEEDED
TO LABEL WIRES AS THEY
ARE DISCONNECTED FROM
OLD THERMOSTAT
M849