Table of Contents
Advertisement
Service (Customer Care)
You cannot hear a ringtone/dialling tone
from the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong pin connections.
¥
Please always use the phone cord supplied
or ensure that the pin connections are cor-
rect when purchasing from a retailer
¢
(
page 10).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000
¢
(
page 68).
Forgotten the system PIN.
¥
Reset the system PIN to 0000
¢
(
page 68).
The other party cannot hear you.
You have pressed the mute button h. The
handset is "muted".
¥
Reactivate the microphone (
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider
to enable Calling Line Identification (CLI).
You hear an error tone when keying an
input (a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the net-
work mailbox.
Your PABX is set for pulse dialling.
¥
Set your PABX to tone dialling.
Gigaset S795 only:
No time is specified for a message in the call
list.
Date and time have not been set.
¥
Set the date and time (
The answering machine announces "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥
Enter the system PIN again.
2. The system PIN is still set to 0000.
¥
Set the system PIN to something other
¢
than 0000 (
72
¢
page 29).
¢
page 15).
page 68).
The answering machine is not recording
any messages/has switched over to answer
only.
Its memory is full.
¥
Delete old messages.
¥
Play back new messages and delete.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain acti-
vated or deactivated. As a pixel is made
up of three sub-pixels (red, green,
blue), it is possible that pixel colours
may vary.
This is completely normal and does not
indicate an error.
Authorisation
This device is intended for analogue
phone lines in the UK.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the
essential requirements and other relevant
regulations laid down in Directive 1999/5/
EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
www.gigaset.com/docs
Advertisement
Table of Contents
