Step 2: Charging The Battery Pack - Sony Handycam DCR-DVD106E Service Manual

Step 2: Charging the battery pack

2
Battery
AC Adaptor
You can charge the "InfoLITHIUM"
battery pack (H series) (p. 101) after
attaching it to your camcorder.
b Notes
• You can use only "InfoLITHIUM" battery pack
H series.
1
Turn the POWER switch in the
direction of the arrow to OFF
(CHG) (The default setting).
2
Attach the battery pack by sliding
it in the direction of the arrow
until it clicks.
3
Connect the AC Adaptor to the
DC IN jack of your camcorder.
Open the jack cover, and connect the
DC plug of the AC Adaptor.
Match the v mark on the DC plug with
the v mark on your camcorder.
20
3 3
Jack cover
DC plug
4
Mains lead
POWER switch
1
DC IN jack
4
To the wall socket
4
Connect the mains lead to the AC
Adaptor and the wall socket.
The CHG (charge) lamp lights up and
charging starts. The CHG (charge) lamp
turns off when the battery is fully
charged.
5
Disconnect the AC Adaptor from
the DC IN jack on your
camcorder.
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
To remove the battery pack
Turn the POWER switch to OFF(CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
CHG
(charge)
lamp