Honeywell HMLCD19 User Manual page 12

Some computer systems are not compatible
with the DDC standard. If your monitor is
displaying the wrong resolution, check your
computer system for a DDC compatible video
card and contact the Service Center.
Do not open the monitor. There are no user-
serviceable components inside. There is
dangerous high voltage inside even when the
power is off. If the display monitor does not
operate properly, remove the power cord from
the wall outlet and contact your dealer. Careless
use and unprofessional maintenance can cause
serious electrical shock and other hazards.
Rev. A 2 HMMU000882
04/09/04
SECTION 3:
OPERATION
3.1 POWER MANAGEMENT
This monitor is equipped with DPMS (Display Power
Management Signaling) function which automatically switches
to power saving mode (less than 5 watts consumed) when the
computer is left unattended. Although the monitor can be left in
power saving mode for longer periods, it is recommended that
you turn it off after your daily work.
The DPMS function requires support from the computer system
of any software DPMS function currently being used. If the
keyboard (or mouse) is left unattended for a certain period, the
program or system will set the sync signals to SPMS modes.
The DPMS function has three states. Recommended signals,
power consumption, and recovery time are shown in the table
below:
Signal
Status
HSync VSync
On Pulse Pulse
No
Standby Pulse
Pulse
No
Suspend Pulse
Pulse
No No
Off
Pulse Pulse
Rev. A
Power Recovery
Consumption Time Indicators
Video
Active 48Watt --
Alternating
Less than Within
Blank Green/Orange
5Watt 2sec
Alternating
Less than Within
Blank Green/Orange
5Watt 2sec
Less than Within
Blank
5Watt 2sec
11 HMMU000882
LED
Green
(1sec)
(0.5sec)
Orange
04/09/04