Cleaning The Dispensers - Maytag Neptune SL-3 Use And Care Manual

C C
LEANING THE
The dispensers may need to be cleaned periodically due to laundry additive build-up. For easy clean-up of the
dispenser, follow the directions for the corresponding dispenser.
Removing the Chlorine Bleach Dispenser
1. Grasp the corner lip of the chlorine bleach dispenser.
Lift the dispenser up and tip it to the right to avoid
hitting the washer frame. (Illustration #1)
2. Under the chlorine bleach dispenser in the dispensing
compartment is an overflow grate. Grasp the
overflow grate by the word "CAUTION" and pull it
up and out of the dispensing compartment.
(Illustration #2)
3. Take the bleach dispenser and the overflow grate to
the sink. Be careful, there may be chlorine bleach left
in the dispenser. Lift the gray siphon cap out of the
chlorine bleach dispenser. (Illustration #3)
4. Run warm water over the dispenser, gray siphon cap
and overflow grate to remove any build-up. A soft
cloth may be used to remove excess residue.
#1
#4
NOTE: Maytag does not recommend placing the plastic dispenser parts in the dishwasher. If laundry additives were
on the parts when washed in the dishwasher, they may cause over-sudsing in the dishwasher.
D
ISPENSERS
#2
#5
Replacing the Chlorine Bleach Dispenser
1. Grasp the overflow grate so the word "CAUTION"
can be read. Place it in the dispensing compartment.
(Illustration #4)
2. Place the gray siphon cap over the stand pipe in the
chlorine bleach dispenser. It should fall into place.
(Illustration #5)
3. Grasp the corner lip of the chlorine bleach dispenser.
Tilt it slightly to the right and insert it back into the
dispenser compartment. (Illustration #6)
#3
#6
8