Troubleshooting - Dryer - Maytag Neptune SL-3 Use And Care Manual

T T
ROUBLESHOOTING
Check these points if your clothes dryer...
Doesn't Run
Doesn't Heat
Doesn't Dry
Is Noisy
Control Knob
Advances
Slowly
Dries Unevenly
Has an Odor
For further assistance, call Maytag Customer Assistance toll-free at 1-800-688-9900 USA or 1-800-688-2002 Canada.
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
- D
RYER
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Press the START button again if the door is opened during the cycle.
• Check fuse or reset circuit breaker.
• Select a heat setting, not AIR FLUFF.
• On a gas dryer, check that the gas supply is on.
• Clean the lint filter and exhaust duct.
• Check all of the above, plus...
• Be sure the exhaust hood at the outside of the home can open and close freely.
• Use 4" rigid metal exhaust duct.
• Do not overload. One wash load = One dryer load.
• Sort heavy items from lightweight items.
• Check that the washer is draining properly to extract adequate water from the load.
• Check the load for objects such as coins, loose buttons, nails, etc. Remove promptly.
• Be sure the Super Stack
Instructions.
• Be sure the rubber feet are installed on the leveling legs.
• Check that the leveling leg lock nuts are tightened.
• This is normal operation for an IntelliDry
cycle. Once the load begins to dry, the control knob will start to advance.The rate
of advancement will be slow at the beginning of the cycle because there is more
moisture in the load. As the load becomes more dry, the control knob will advance
more quickly.
• Seams, pockets and other similar heavy areas may not be completely dry when the
rest of the load has reached the selected dryness level. This is normal. Select the
MORE DRY setting if desired.
• If one heavy item is dried with a lightweight load, such as one towel with sheets, it is
possible that the heavy item will not be completely dry when the rest of the load
has reached the selected dryness level. Sort heavy items from lightweight items for
best drying results.
• Household odors such as from painting, varnishing, strong cleaners, etc. may enter
the dryer with the surrounding room air. This is normal as the dryer draws the air
from the room, heats it, pulls it through the tumbler and exhausts it to the outside.
When these odors are present in the air, ventilate the room completely before using
the dryer.
is leveled properly as outlined in the Installation
TM
cycle, especially at the beginning of the
®
22