Install female end of driveline onto Tiller
gearbox input shaft and secure with proper
quick locking device Fig. 3.
Attach three point hitch mast struts and
driveline shield to tiller frame using M12x30
bolts, lock washers and nuts Fig.2.
Attach mast braces to mast struts using
Secure mast brackets onto clamps on gearbox
housing using a M12x80mm spacer, nut and
Install hitch.pin brackets onto frame using two
Brackets must be installed with the weld nut
6 Check gearbox oil level per instructions in
7 Make certain
8 Check the tiller tine bolts to ensure they are
9 Apply a coating of grease to the telescoping
10 Using a grease gun and a multi-purpose
on top side maintaining a distance of
centered between brackets. Fig.
all safety shields and safety
in place and in good condition.
Torque to 73 ft. lbs. (10.1
parts of the driveline Fig. 8.
grease, ensure the tiller tine shaft and the
driveline are lubricated Fig. 9