Samsung RS 24 Service Manual page 28

Operation Function
2) Preparation of Ice-maker
2-1) Connect the water line to the water supply valve of refrigerator to supply water. (See how to connect a water
supply line in the owner's manual.)
2-2) Push the bucket back fully so that the guide-ice of ice maker should not touch the back of bucket. (If the back of
bucket touches the guide-ice of ice maker, the ice maker will not make ice any more because of a ice full signal.)
2-3) It takes 6 hours to have a first ice, and throw away 2-3 times of these ice to make sure the supplied water clean.
1) Initial Operation function
1-1) Whenever the power is on, the control board checks the ice tray leveling with the leveling switch within 2 seconds.
1-2) If the leveling switch is not off position, the geared motor will turn to the initial position to make the ice tray leveled.
1-3) When the ice tray is leveled, it will remain this position for 2 hours (1 cycle time for ice production).
1-4) After 2 hours, the sensor located under the ice tray will measure the tray temperature. If the temperature is
maintained lower than -7
begin.
<Reference table>
Leveling S/W
ON("LOW")
ON("LOW")
OFF("HIGH")
OFF("HIGH")
for 5 minutes, and the ice full switch is off position, the ice tray twisting process will
Ice full S/W
ON("LOW")
OFF("HIGH")
ON("LOW") Not ready(Ice bucket with full of ice )
OFF("HIGH")
28
Push the bucket back fully so that the
lever should not be pushed up.
Judgement
Not ready
PIN #51: Leveling
Not ready
PIN #51: Ice full
OFF : 4.5V
Ready
ON : 0.5V ↓
Remark
MICOM Port
Port level
↑