Self-Diagnosis And Special Mode Setting; Service Mode Summary Table; Service Mode Table (Main Unit) - Panasonic SA-PT650P Service Manual

SA-PT650P / SA-PT650PC

9 Self-Diagnosis and Special Mode Setting

9.1.

Service Mode Summary Table

The service modes can be activated by pressing various button combination on the main unit and remote control unit.
Below is the summary for the various modes for checking:
Player buttons Remote control unit buttons
STOP
STOP+
Note:
An error code will be canceled if a power supply is turned OFF.
*1: CPPM is the copy guard function beforehand written in the disk for protection of copyrights.
*2: CEC is the consumer electronic control used for high-level user control of HDMI-connected devices.
*3: HDCP is the specification developed to control digital audio & video contents transmission for DVI or HDMI connections.
9.2.

Service Mode Table (Main Unit)

By pressing various button combinations on the main unit and remote control unit, you can activate the various service modes for
checking.
Special Note:
Due to the limitations of the no. characters that can be shown on the FL Display, the "FL Display" button on the remote control
unit can be used to show the two display pages. (Display 1 / Display 2).
· Refer to Section 7.1 for the section on "Remote Control Key Buttons Operations".
0 Error code check.
5 Jitter checking.
PAUSE Initial setting of laser drive current.
FUNCTIONS DVD laser drive current check.
1 ADSC internal RAM data check.
3 CD laser drive current check.
6 Region display and mode.
7 Micro-processor firmware version check.
Initialization of the player (factory setting is restored).
Used after replacement of Micro-processor (DV5 LSI) IC, FLASH
ROM IC (IC8651), EEPROM IC (IC8611) and DVD Module
P.C.B.
8 DVD Module P.C.B. firmware version check.
MENU Communication error display.
TOP MENU ECC error check.
EQ CPPM/CRM keys check.
ENTER DVD Module P.C.B. reset.
Timer 1 check.
Timer 1 reset.
Timer 2 check.
Timer 2 reset.
1 Combination reliability test mode.
2 OPEN/CLOSE reliability test mode.
3 Tray rotation reliability test mode.
Application
32
Note
(Refer to the section
"9.2.1. Service Mode
Table 1" for more
information.)
(Refer to the section
"9.2.2. Service Mode
Table 2" for more
information.)
(Refer to the section
"9.2.3. Service Mode
Table 3" for more
information.)
(Refer to the section
"9.2.4. Service Mode
Table 4" for more
information.)
(Refer to the section
"9.2.5. Service Mode
Table 5" for more
information.)
(Refer to the section
"9.2.7.1. Test Mode List"
for more information.)