Av Input Setup; Av Output Interface Setup; External Device Control - Kenwood DNX890HD Quick Start Manual

Return to the Top page
Setting Up

AV Input Setup

You can set AV input parameters.
1
Touch [Menu] on any screen.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [Source].
4
Touch [AV-IN SETUP] in the list.
AV-IN SETUP screen appears.
5
Set each item as follows.
iPod AV Interface Use* 1
Sets the terminal which iPod is connected.
Setting values are iPod and AV-IN2.
iPod (Default): Set this when an iPod is
connected using KCA-iP202
connector. You can listen to
audio or watch video in your
iPod as iPod source.
AV-IN2: Set this when an iPod is connected
using KCA-iP102 connector.You can
listen to audio in your iPod as iPod
source. You can also listen to audio or
watch video output from a AV device
as AV-IN2 source.
98 98
AV-IN1 Name/AV-IN2 Name*
2
Sets a name to be displayed when you select
a system that is connected via the AV INPUT
port. Default is "VIDEO".
*1 T his item can be set when in STANDBY
source and also the iPod is disconnected.
*2 [ AV-IN2 Name] becomes settable when
"AV-IN2" is selected in [iPod AV Interface
Use].

AV Output Interface Setup

You can select an AV source to be output at
the AV OUTPUT port. Default is "VIDEO1".
1
Touch [Menu] on any screen.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [AV-OUT].
AV-OUT Interface screen appears.
4
Touch [2] or [3] to set [AV-OUT] to
VIDEO, DISC, iPod, or OFF.
Return to the Top page
Setting Up

External Device Control

Control the external device power supply.
1
Touch [EXT SW] in the Source Control
screen.
EXT SW Control screen appears.
NOTE
• If [EXT SW] is not displayed, touch [ ].
2
Touch the desired switch key.
You can turn on or off the external device
power supply.
NOTE
• You must connect a commercially available relay
unit in order to use this function. Connect the
external device to be controlled to that relay unit.
• See EXT SW setup (P.90) for information on
setting the power on or off specification.
99