Table of Contents
Advertisement
10. STORAGE
Preparation
for Storage
When the mower will not be used for one month or longer, proper storage
preparation will help to prevent rust and corrosion, and will make it easier to
start the engine when the mower is removed from storage.
I
1. Clean all surfaces of the mower, including the area underneath the cutter
deck. Wear heavy gloves to protect your hands.
NOTE: Before cleaning under the cutter deck, turn the fuel valve OFF, and
rest the mower on its right side, so the carburetor side is up Hard starting
and fuel leakage may result if the mower is placed with the carburetor side
down.
If you use
a
garden hose to wash the mower, observe the following
precautions:
l
If the mower has been running, allow the engine to cool for at least half
an hour before spraying water on it. Never spray water on a hot engine
l
Wash the mower using low water pressure, and keep water away from
controls, cable ends, wheel hubs, and all other places that are difficult
to dry if water enters.
l
After washing, start the engine outdoors, and let it run until it reaches
normal operating temperature to evaporate any water remaining on the
engine . Operate the ROTO-STOP lever 4 or 5 times to expel water from
the ROTO-STOP mechanism; allow the blade to spin for several minutes
to ensure that no water remains.
l
Stop the engine, turn the fuel valve OFF, and allow the engine to cool
before placing the mower in storage
2. Wash the grass bag, and allow it to dry completely.
lMPOmANT
NOTlCE
1 Stored lawn clippings
are a fire hazard. Always
empty
the grass bag after.use.
3. Coat areas that may rust with
a
light film of oil. Lubricate all control cable
cores with a silicone spray lubricant.
46
Advertisement
Table of Contents
