Honda H5013 Owner's Manual page 25

1. Hydraulic cylinder selector lever (Rear hydraulic lift type only, option)
The
rear
the front or oil pressure from the oil pump can be changed to either oil pressure from the oil pump can be changed to either the front or
hydraulic system by operating this lever. hydraulic system by operating this lever.
T T
HYDRAULIC CYLINDER CHANGE LEVER HYDRAULIC CYLINDER CHANGE LEVER
I
IMPORTANT NoTlCE 1 Always move the lever fully into the Front or Rear!
position. Leaving the lever halfway between these two positions may
damage the hydraulic system or interfere with its normal operation.
Observe the following when operating the hydraulic cylinder selector
lever:
- 1. To prevent lowering of attachn-ient, turn the descent speed adjust
knob clockwise fully to SLOW.
- 2. Place the lift lever in the DOWN position.
- 3. Place the selector lever in the FRONT or REAR position.
- 4. Turn the descent speed adjust knob out as necessary to obtain the
desired speed.
23