Download  Print this page

Advertisement

Adjustment
[Adjustment standard]
The right edge of the needle must align with the rotary hook point when the needle bar raised 2.9 to 3.3mm up from
its lowest position.
[Adjustment procedure]
1. Remove the presser foot, the needle plate B and the needle plate A, then remove the inner rotary hook.
2. Start the test mode.
3. Select the pattern number "02" (3-point needle drop mode).
4. Press
(Reverse/reinforcement stitch button) and move the needle bar to the left base line, then turn off the
power.
5. Turn the pulley by hand and move the needle bar to its lowest position.
6. Remove the base cover.
7. Loosen the 2 screws (set screws socket (CP) M5 x 5) of the lower shaft pulley D with the hex wrench (2.5mm).
8. Turn the pulley by hand and raise the needle bar 2.9 to 3.3 mm from its lowest position, then turn the outer rotary
hook by hand and align the right edge of the needle with the outer rotary hook point.
9. Tighten the 2 screws (set screws socket (CP) M5 x 5) of the lower shaft pulley D.
4 - 10

Needle bar rising

The right edge of the needle aligns with the
outer rotary hook point when the needle bar
raised 2.9 to 3.3mm up from its lowest position.
2.9 - 3.3mm
Set screws socket
(CP) M5 x 5 (2pcs.)
Hex wrench
Lower shaft pulley D
(2.5mm)

Advertisement

Table of Contents

   Related Manuals for Brother CE-5500PRW

Comments to this Manuals

Symbols: 0
Latest comments:
  • Debbie Doebley Sep 04, 2018 10:52:
    I have the Brothers sewing machine CP6500, only got Spanish manual with the machine and I do not speak, etc Spanish. I was sewing with my machine then had to change the tension and now I am having a lot of trouble getting it to work properly again, thread from bobbin bunches up(?), Is there any way I can get the manual in English so I can try to get my machine working properly again? I would really appreciate any help you can give me. If need to you can email @ debbiedoeb​ley@aol.co​m. My home address is 3122 Belgreen Place, Philadelph​ia, Pa 19154. Thank You!