Download  Print this page

Attachment Of Needle Holder Shaft A; Attachment Of Z Zigzag Adjusting Nut - Brother CE-5500PRW Service Manual

Computerized.
Hide thumbs

Advertisement

Application of Assembly
11

Attachment of Needle holder shaft A

1. Insert the needle holder shaft A 1 to the upper side hole of the needle bar
supporter assy., and then insert the shaft 2 into the needle bar supporter
assy., the needle holder shaft A 1 and the needle bar supporter assy..
*Key point
• Check that the groove 3 of the shaft 2 is the left side, when
set the needle bar supporter assy. as shown in the right figure.
2. Set the plate 4 to the needle bar supporter assy. with the screw 1.
*Key point
• Check that the groove 3 of the shaft 2 engaged with the
notch part 5 of the plate 4.
3. Attach the screw 2 to the needle holder shaft A 1.
S09
4. Attach the spring
*Key point
• Attach the hook side of the spring to the plate 4.
Apply FBK OIL RO 100 to the needle holder shaft
A.
1
2
S09
12

Attachment of Z zigzag adjusting nut

1. Set the Z zigzag adjusting nut 1 to the needle bar supporter assy., and then
tighten the screw 1 temporarily.
*Key point
• Check that the side of the zigzag adjusting nut 1 with the
greatest eccentricity toward the top (see figure at the right).
• Fully tighten the screw 1 after performing "4-7 Adjustment :
Left base line needle drop".
Apply EPNOC AP (N) 0 to the zigzag adjusting nut
Z zigzag lever contact surface.
1
3 - 86
Needle-presser module
to the plate 4 and the needle bar supporter assy..
Screw, Bind
M3X5
Set Screw, Socket (CP)
M3X5
23
4
Bolt, Socket
M3X10
1-2 drops
XC8388***
Torque
0.59 – 0.78 N·m
Torque
0.59 – 0.78 N·m
SPRING
X50476***
Bead
XC8387***
Torque
Hand start
2
1
3
5
1
2
4
4
S09
1
1

Advertisement

Table of Contents

   Related Manuals for Brother CE-5500PRW

Comments to this Manuals

Symbols: 0
Latest comments:
  • Debbie Doebley Sep 04, 2018 10:52:
    I have the Brothers sewing machine CP6500, only got Spanish manual with the machine and I do not speak, etc Spanish. I was sewing with my machine then had to change the tension and now I am having a lot of trouble getting it to work properly again, thread from bobbin bunches up(?), Is there any way I can get the manual in English so I can try to get my machine working properly again? I would really appreciate any help you can give me. If need to you can email @ debbiedoeb​ley@aol.co​m. My home address is 3122 Belgreen Place, Philadelph​ia, Pa 19154. Thank You!