Heat Sinks; Removing The Heat Sink - Dell PowerEdge C2100 Hardware Owner's Manual

Servers
Hide thumbs Also See for PowerEdge C2100:
Table of Contents

Advertisement

Heat Sinks

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.

Removing the Heat Sink

1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 58.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 60.
4 If required, remove the expansion-card riser assembly. See "Removing the
Expansion-Card Riser" on page 75.
WARNING:
powered down. Allow the heat sink to cool before handling it.
CAUTION:
to remove the processor. The heat sink is necessary to maintain proper
thermal conditions.
5 Using a #2 Phillips screwdriver, loosen one of the heat-sink captive screws.
See Figure 3-8.
Wait 30 seconds for the heat sink to loosen from the processor.
6 Loosen the screw that is diagonally opposite to the screw that you have
already loosened. See Figure 3-8.
7 Repeat step 5 till you have loosened the remaining screws.
8 Gently lift the heat sink off the processor and set the heat sink aside with
the thermal grease side facing up.
62
Installing System Components
Many repairs may only be done by a certified service technician.
The heat sink is hot to touch for some time after the system has been
Never remove the heat sink from a processor unless you intend

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents