Stopping The Engine; Emergency Engine Stopping; Side-Mount Type - Honda Outboard Motor BF200A Owner's Manual

OPERATION
N (neutral)
FAST IDLE BUTTON
4. Before getting under way, allow
the engine to warm up sufficiently
to ensure good performance.
Above 41 "F (5"C), warm up the
engine for 2 or 3 minutes.
Below 41 "F (5"C), warm up the
engine for at least 10 minutes at
2,000 rpm. Push the fast idle
button then move the control lever
forward or reverse to open the
throttle and achieve approximately
2,000 rpm.
During the warm-up period, check
the oil pressure indicator (p. 29
),
overheating indicator (p. 29 ), and
cooling system indicator (p. 30).
If the indicators show any
abnormal condition, immediately
stop the engine and determine the
cause of the problem. Refer to
TAKING CARE OF
UNEXPECTED PROBLEMS, p.
82.
5.
If the fast idle control was used to
warm up the engine, gradually
return the control lever to the N
(neutral) position as the engine
warms up.
STOPPING THE ENGINE
Emergency Engine Stopping
Side-Mount Type
EMERGENCY
STOP SWITCH
Panel-MountITop-Mount Types
\
//
LANYARD
SWITCH CLIP
43