Lenovo ThinkPad X200 tablet Hardware Maintenance Manual page 38

Table 1. FRU tests
FRU
System board
Power
LCD unit
Audio
Speaker
PC Card slot
ExpressCard slot
Keyboard
Hard disk drive
Diskette drive
Optical drive
Memory
TrackPoint or pointing
device
30
ThinkPad X200 Tablet and X201 Tablet Hardware Maintenance Manual
Applicable test
1. Diagnostics>CPU/Coprocessor
2. Diagnostics>Systemboard
3. If the ThinkPad X200 UltraBase™ is attached to the ThinkPad computer, detach
it. Place the computer on a horizontal surface, and run Diagnostics>ThinkPad
Devices>HDD Active Protection Test.
Note: Do not apply any physical shock to the computer while the test is running.
Diagnostics>ThinkPad Devices>AC Adapter, Battery 1 (Battery2)
1. Diagnostics>Video Adapter
2. Interactive Tests>Video
Enter the BIOS Setup Utility and change Serial ATA (SATA) setting to Compatibility,
and run Diagnostics>Other Device>Conexant Audio
Interactive Tests>Internal Speaker
Note: Once Modem/Audio test is done, the no sound is heard this test. In this case,
turn off and turn on the computer. Then, run this test again.
Diagnostics>Systemboard>PCMCIA
1. Insert a PCI-Express/USB Wrap card into the ExpressCard slot.
2. Turn on the computer.
3. Run Diagnostics>ThinkPad Devices>ExpressCard slot.
1. Diagnostics>Systemboard>Keyboard
2. Interactive Tests>Keyboard
Enter the BIOS Setup Utility and change Serial ATA (SATA) setting to Compatibility,
and run Diagnostics>Fixed Disks
You can also diagnose the hard disk drive without starting up the operating system. To
diagnose the hard disk drive from the BIOS Setup Utility, do as follows:
1. Remove any diskette from the diskette drive, and then turn off the computer.
2. Turn on the computer.
3. While the message, "To interrupt normal startup, press the blue ThinkVangate
button," is displayed at the lower left of the screen, press F1 to enter the BIOS
Setup Utility.
4. Using cursor keys, select HDD diagnostic program. Press enter.
5. Using cursor keys, select Main hard disk drive or Ultrabay hard disk drive.
6. Press Enter to start the diagnostic program.
1. Diagnostics>Diskette Drives
2. Interactive Tests>Diskette
1. Diagnostics>Other Devices>Optical Drive
2. Interactive Tests>Optical Drive Test
1. If two DIMMs are installed, remove one of them and run Diagnostics>PM Memory.
2. If the problem does not recur, return the DIMM to its place, remove the other one,
and run the test again.
If the TrackPoint does not work, check the configuration as specified in the BIOS Setup
Utility. If the TrackPoint is disabled, select Automatic to enable it.
After you use the TrackPoint, the pointer may drift on the screen for a short time. This
drift can occur when a slight, steady pressure is applied to the TrackPoint pointer.
This symptom is not a hardware problem. If the pointer stops after a short time, no
service action is necessary.
If enabling the TrackPoint does not correct the problem, continue with the following:
• Interactive Tests >Mouse