Maintenance; Auxiliary Fuse Replacement - Honda BF45A Owner's Manual

_ 10. MAINTENANCE
Auxiliary Fuse Replacement
I P4 1
BLOWN FUSE
AUXILIARY FUSE RATING: 10A
If the auxiliary fuse is blown, the
electric starter will not work but the
power trim will work.
If the main fuse is blown, neither the
starter or the power trim will work.
'Ihe main fuse is located on the sole-
noid bracket inside the engine cover.
Never use a fuse with a different rat-
ing from that specified.
If the fuse is blown, check the cause,
then replace the fuse with a fuse of
the same rated capacity. Unless the
cause is found, the fuse may blow
again.
WIRING HARNESS
\
FUSE
HOLDER
CAP
CABLE TIE
/
RUBBER END CAPS
Replacement
1. Stop the engine.
2. Loosen the cable tie and slide it
down the wiring harness.
3. Slide the rubber end caps back.
4. Unscrew the fuse holder cap.
5. Remove the fuse.
6. Install a new 10A fuse.
If a spam fuse.is not available, the
motor will need to be started with
the pull starter rope (refer to the
emergency start procedure).
13