Kenwood KMR-330 Instruction Manual page 17

Installation
Sleeve install ti on
Bend the tabs of the mounting
sleeve with a screwdriver or similar
utensil and attach it in place.
~
~
Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
Bracket installation
1
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory@
Removal tool
2
When the upper level is removed, remove the
lower two locations.
~
~
• The frame can be removed from the bottom side in the
same manner.
Removing the Unit
~\\~~
~-"",~.
'\
Accessory@
Hl
smm
~~MAX.
1---1
0Smm
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Insert the two removal tools deeply into the slots
on each side, as shown.
3
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
Accessory@
it.
• Be careful to avoid injury from the catch pins on the
removal tool.
4
Pull the unit all the way out with your hands, being
careful not to drop it.
English
I
17