Checking Ipass Connector To Host System; Check If Ipass Board (Gs-Ipass2 / Gs-Ipass3) Is Installed Properly - Dell PowerEdge C410x Hardware Owner's Manual

Checking iPass Connector to Host System

1. Check the Board to Board (BTB) connectors to the iPass Boards.
2. Check System SMBus device routing table.
IPASS TOP
iPass 1: Slot 1/15
iPass 2: Slot 3/13
iPass 3: Slot 5/11
iPass 4: Slot 7/9

Check if iPass Board (GS-IPASS2 / GS-IPASS3) is installed properly

1. See Replacing iPass Board on page 40 for instructions to accessing the iPass boards.
2. Reverse the steps above to reassemble the system.
3. Restart system and test again.
IPASS Bottom
iPass 5: Slot 2/16
iPass 6: Slot 4/14
iPass 7: Slot 6/12
iPass 8: Slot 8/10
Troubleshooting Your System | 101