Remote Control Battery Installation; Remote Control Operating Range; Remote Control Code - Sanyo PLC-XU300A Owner's Manual

Part Names and Functions

Remote Control Battery Installation

Open the battery
1
compartment lid.
To ensure safe operation, please observe the following precautions :
Use two (2) AAA or LR03 type alkaline batteries.
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
Risk of an explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Remote Control Operating Range

Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5 m)
and 60 degrees in front of the projector.

Remote Control Code

The 2 different remote control codes (Code 1–Code 2) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See "Remote control" in the Setting Menu on page 53.
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the Code 1 and Code
2. The initial code is set to Code 1.
12
Install new batteries
2
into the compartment.
Two AAA size batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
Replace the
3
compartment lid.
16.4'
(5 m)
30°
30°
Remote control
W h i l e p r e s s i n g t h e
MENU button, press the
more
IMAGE button
than five seconds to
switch between the
codes
.
MENU button
IMAGE button