Adjustment - LG WF-T851 Service Manual

Table of Contents

Advertisement

9. ADJUSTMENT

Wire
Brake
Lever
Adjustment
Screw
Clutch lever
Brake
lever bar
2.5~3.5mm
Clutch Pulley
2.5~3.5mm clearance
should be obtained.
Keep the clearance than
1.9
0.1mm between
the tip of the adjustment
screw and brake lever
PV Link
Adjust theV-belt as
shown in the figure.
Motor
Pulley
9-1. BRAKE LEVER ADJUSTMENT
• Shown as in the figure, untighten the adjustment
screw to keep clearance 1.9¡¾0.1mm between
the tip and the brake lever.
And turn on the lock nut then paint it red.
¡á CAUTION
CAUTION
• Painting part is adjusted in factory, it does not
need adjusting.
• Adjust the screw properly if the brake doesn't
work during spin.
9-2. KEEPING CLEARANCE
• Keep the clearance about 2.5~3.5mm between
brake lever and P.V link as shown in the figure.
¡á CAUTION
CAUTION
• Clutch pulley must be turning to one side when
P.V link is pulling the brake lever.
• Clutch pulley must be turning to the left and the
right when P.V link does not pull the brake
Lever.
9-3. V-BELT ADJUSTMENT
• Adjust the motor pulley by pushing the motor like
arrow ¥L, to make V-belt tension parallel
when pushed at the point of arrow ¥M .
¡á CAUTION
CAUTION
• When the V-belt is not properly adjusted, the
motor will not be running or the belt will be
slipping.
45

Advertisement

Table of Contents
loading

Table of Contents